Wednesday, September 12, 2007

You'll never guess what I worked on tonight!

I pulled out the Elecraft K1 kit and started work on the second component, the Front Panel Board. I was surprised at how fast I progressed on this component. I'm about 1/2 way done in one sitting of about an hour and a half.

Front Panel Board - Top

Front Panel Board - Bottom

The filter board's components were all mounted on one side and soldered on the other, well, except for the multi pin connectors. The Front Panel Board is a little different, it has components mounted on each side, with some solder points ending up below components on the other side, I sure hope I don't have to re solder anything. I hope I can finish this component without letting too much time pass.

No comments: